TS 2000

9a5st · 08. February. 2008, 21:04:01

Eto stiga meni uredjaj.Samo me nesto interesira,da li neko zna kako dobit otvorenu predaju na svim frekvancijama?
Bija bih veoma zahvalan!!!
73 de 9A5ST
Zeky

9A3GE · 08. February. 2008, 21:12:02

Zeky....sutra razmotrimo tvoje pitanje...tu budemo nešto "kemijali" sa stanicama....ja mišlem da more...? Sve more bolan ? 9A3GE

9A3GE · 08. February. 2008, 21:13:14

Kao ovaj gore ? 3GE

9A9T · 08. February. 2008, 22:36:35

Izvoli Zeky, ovo si tražio...

•   Disconnect power cord and antenna from the transceiver.

•   Remove the top and bottom covers.

•   Remove the top screw from each side of the front panel assembly.

•   Loosen the bottom screw from each side of the front panel assembly.
•   Carefully rotate the front panel forward to gain access to the control board(X53-3910-11). This board is mounted vertically against the body of the transceiver. It is not the board that is mounted in the front panel assembly.

•   Locate and remove resistor R53 from the control board.

•   Assemble the transceiver then perform the CPU reset procedure by holding the A=B button in while turning on the power.
Transmit Range: 1.705-30MHz, 49-54MHz, 142-152MHz, 420-450MHz, 1240-1300MHz.

Pozdrav, Tom!

9A9T · 08. February. 2008, 22:40:09

Zaboravio sam napisati, ima na internetu dosta tih uputa sa slikama gdje se nalazi R53 koji to u stvari i nije nego samo "brika" bez otpora. Znači samo ga uniši i imaš prošireni TX.

Sretno!

9A9T · 10. February. 2008, 11:57:54

Zeky,
izvoli adresu,malo pogledaj...ima i ovo proširenje a i neke druge stvari.

http://www.kb2ljj.com/

Tu odi na Mods pa na Kenwood i biraj TS2000.

GL

9a5st · 10. February. 2008, 19:52:15

Zahvaljujem ekipa !!!
73 de Zeky