Eto stiga meni uredjaj.Samo me nesto interesira,da li neko zna kako dobit otvorenu predaju na svim frekvancijama?
Bija bih veoma zahvalan!!!
73 de 9A5ST
Zeky
Zeky....sutra razmotrimo tvoje pitanje...tu budemo nešto "kemijali" sa stanicama....ja mišlem da more...? Sve more bolan ? 9A3GE
Kao ovaj gore ? 3GE
Izvoli Zeky, ovo si tražio...
• Disconnect power cord and antenna from the transceiver.
• Remove the top and bottom covers.
• Remove the top screw from each side of the front panel assembly.
• Loosen the bottom screw from each side of the front panel assembly.
• Carefully rotate the front panel forward to gain access to the control board(X53-3910-11). This board is mounted vertically against the body of the transceiver. It is not the board that is mounted in the front panel assembly.
• Locate and remove resistor R53 from the control board.
• Assemble the transceiver then perform the CPU reset procedure by holding the A=B button in while turning on the power.
Transmit Range: 1.705-30MHz, 49-54MHz, 142-152MHz, 420-450MHz, 1240-1300MHz.
Pozdrav, Tom!
Zaboravio sam napisati, ima na internetu dosta tih uputa sa slikama gdje se nalazi R53 koji to u stvari i nije nego samo "brika" bez otpora. Znači samo ga uniši i imaš prošireni TX.
Sretno!
Zeky,
izvoli adresu,malo pogledaj...ima i ovo proširenje a i neke druge stvari.
http://www.kb2ljj.com/
Tu odi na Mods pa na Kenwood i biraj TS2000.
GL
Zahvaljujem ekipa !!!
73 de Zeky